A shower valve is perhaps the most important component of a tub shower system. For the most part, this is a two-way valve that works to control the water flow of the bathtub spout or shower head. There are generally two types of shower valve: First, you have a notched lever type that is pulled or pushed to control the water flow. Secondly, there is a handle type that rotates to control the valve. When looking for best shower valves, it is important to consider the style of the bath fixture that it’s designed for as well as the durability. You need a valve that can last for years. A valve can be in the bathtub spout of some showers and you might have to replace the whole spout at certain point. Other shower faucets will have a valve for a third water control handle and this would sit between the handles for cold and hot water. This means that you would remove an old valve to install a brand new one, just like when you are repairing a faucet leak. Tub shower valve DIY Tips for Shower Valve Repair If you have an in-spout , you would start by removing the screw that is used to hold the tubs spout. If there is no screw at the bottom, you can wrap the spout with a piece of cloth, clamp on a pipe wrench and turn the tub spout in a counter clockwise direction to remove it from the water pipe. The next step is to install the replacement spout on the water pipe, in the same location as the , using the process that was used to remove the old spout. You can screw a plastic adapter into the spout opening before installing if the new spout opening is too big for the pipe.For hand held shower valve: Close the main water valve to switch off the water supply in the house. Turn the shower faucet on completely to eliminate any kind of pressure that is left in the water pipes. Remove the small cap in the middle of the shower ’s control knob. A Phillips screwdriver can be used to remove the screw from under the cap and then you would pull off the handle from the faucet. Use pliers to unscrew adapter nuts or pieces from the valve stem. Needle-nose pliers can remove any metal clips or pins. Slide the faucet handle across the stem valve and then turn counter clockwise to remove the valve from the water pipe. A new valve can now be screwed into the pipe and the handle turned clockwise until it is sitting securely in place. Replace all the other faucet parts using reverse steps to the ones used for the removal. After that, you can turn on the main water valve inside the house. Hopefully, you will know more about shower valve and how to repair it after reading this article.
0 Comments
Leave a Reply. |
|